[dorkbotpdx-blabber] Re: Buying the stuff to make PCBs..

[Laen]

What about tinning the board?  Is that necessary, or does using flux
take care of it?

When buying the FR4 boards, what do you look out for as far as copper
width and board width, or does it really matter much?

Thanks!
-Laen

On Oct 15, 2:31 pm, "Mr.T" <drtw... at aracnet.com> wrote:
> Stuff that works for me:
>
> Toner Transfer Paper:http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail?name=182-...
>
> Green TRF:http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail?name=182-...
>
> Ferric Chloride or Ammonium Persulphate :
> go to Norvac
>
> I _really_ like using a laminator like the GBC H110 from office depot
> or you can use a hobby iron likke Don does.
>
> as far as pcb material goes look on Ebay  for "FR4" and you can find some
> super cheap stuff.
>
> _eric
>
> _____________________________
> Drtwist:
> drtw... at aracnet.com
>
>
>
> On Wed, 15 Oct 2008, Laen wrote:
> > I'm interested in getting the tools and materials to do my own PCBs.
> > Problem is, I don't really know where to start.
>
> > Obviously, copper clad board is a must.  I think I overheard that Don
> > and Eric get theirs from Surplus Gizmos. Is that right?
>
> > I like Jason's blue toner transfer paper.  Is that this stuff?
> >http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail?name=182-...
>
> > Other than that..  Etching chemicals?  A tank to hold the chemicals
> > when etching?  Flux and flux remover? Special Dremel tips? Any
> > suggestions, or anything else?
> > _______________________________________________
> > dorkbotpdx-blabber mailing list
> > dorkbotpdx-blab... at dorkbot.org
> >http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber
>
> _______________________________________________
> dorkbotpdx-blabber mailing list
> dorkbotpdx-blab... at dorkbot.orghttp://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber